[amayausers] Re: thread question
- From: "Lee or Terri Hoover" <lhoover2@xxxxxxxxxxxxxxxx>
- To: <amayausers@xxxxxxxxxxxxx>
- Date: Thu, 28 Sep 2006 16:52:06 -0500
Thanks. Actually it's a design I've sewn on hats with good results before.
However, today these are different hats, the autoactifeed was going to 1
(structured hat) so using manual.
I can see the core of the spool. So I was just wondering if there is any
tensile strength difference in the beginning or end of a spool...
Terri
Embroidery Creations
-----Original Message-----
From: amayausers-bounce@xxxxxxxxxxxxx
[mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of Kesavan
Sent: Thursday, September 28, 2006 4:00 PM
To: amayausers@xxxxxxxxxxxxx
Subject: [amayausers] Re: thread question
Terri,
Over dying used to happen a lot probably 12+ years ago. I am not sure it
happens much anymore.
Try polyester thread and if you still have problems try changing the
needle number you are sewing on or check your design.
I can have a look at the design for you at no charge if it is happening
with a particular design.
Anand
Just some musing for this afternoon.. I understand that black thread
is
the weakest due to the over dying. Are spools of thread weaker nearer
the cone or outside? If so, is it only on certain colors? Does it
matter for 1000 M vs. 5000 M cones?
Terri
Embroidery Creations
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.407 / Virus Database: 268.12.9/458 - Release Date:
27/09/2006
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
Other related posts:
