This message was posted by djames on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/2/546.html#000003 Cindy, Actually, you need to set the jump count to a higher number. This tells the machine how many jumps it will accept before it trims. You can save your design as an EXP and go in and look at the stitches tool bar for the particular stitches in question and you will see how many jumps have been inserted into the design. Set your jump count higher than the most jumps that you see. Debbie =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================