[amayausers.com] Re: density for metallic thread

This message was posted by cjk on AmayaUsers.com. PLEASE DO NOT REPLY VIA 
EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: 
http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/2/1257.html

I have a fsl design that has metallic thread being used as small flower 
outlines.  I can sew it ok on my voyager but my amaya doesn't care at all for 
it.  I have tried different backing, giving up on the vilene for the amaya and 
going to a 2 piece backing of mesh, changed the needle and I still get maybe 3 
stitches and then the thread breaks.  It is slowed down to 800, pressure foot 
all the way down, 80/12 needle, so my conclusion is that maybe I need to change 
the density for the amaya.  Its already set to 11.7.  Any suggestions as to 
what to change it to?  Thanks,Cheryl K.

=========================================================== 

The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list

===========================================================

Other related posts: