If the previous does not work, push the Emergency Stop, then reach up behind the needle case and find the z axis shaft (it is visible in a square cutout behind the needle case), you can rotate it with your hand to bring the needle back up. Then re-engage the Emergency Stop (twist it), you may get a "not at head up" warning, if so go to "maintenance/head timing" and give the machine a head up command. Herb ----- Original Message ----- From: "Kesavan" <kesavan@xxxxxxxxxxxxxx> To: <amayausers@xxxxxxxxxxxxx> Sent: Wednesday, May 31, 2006 7:20 PM Subject: [amayausers] Re: Trace >I have got x Axis time out error. > > The needle is down and the grabber is stuck behind the needle. > > They are both stuck together > > How do I free them. > > Anand > =========================================================== > > The AmayaUsers Mailing List > Website: http://www.amayausers.com > Discussion Board: http://www.amayausers.com/boards > Subscribe/Unsubscribe: http://www.amayausers.com/list > > =========================================================== =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================