Roland, You're welcome. I hope the colors are an OK match. I prefer Madeira thread, too. I've been using it for years. The Amaya thread rack isn't totally compatible with the Madeira cones. Madeira is using a new cone that's better, but it's still a little too tall. I've swapped out some of the cone holders on the thread rack with older ones from an EMT, which are a good bit longer. That, combined with the new Madeira cones, works great. I can get the Madeira spools to work pretty well, too, using some advice from Aaron (I think). Mary Mary Buckle Shuffletown Embroidery Charlotte, NC 704-398-1273 -----Original Message----- From: amayausers-bounce@xxxxxxxxxxxxx [mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of Roland R. Irish III Sent: Tuesday, August 08, 2006 4:34 PM To: amayausers@xxxxxxxxxxxxx Subject: [amayausers] Re: Thread Conversion Thanks Mary...all I have in-house for now is the full 288 ARC spools and a few larger spools of the most common colors, but as we run out of any color we switch to Madiera because we can get those overnite with no problem or even drive over and pick them up. It figures none of these colors are ones we have yet...but once we start going into production we'll switch over. Thanks! Roland =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list =========================================================== =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================