This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/2/1197.html#000001 Hi Lisa, There are several things we need to know in order to help. 1. What design? Is it a purchased logo like Dakota Collectibles....or one someone digitized? Remember that Dakota designs are "bullet proof" meaning they don't know what you will be sewing it on so they beef up the design. You can almost always take out at least 10% of the stitches and often more for the design to sew well. Did you resize the design? Most of the time never resize more than 20%. 2. If there is "loft" to the blanket, you need to put the presser foot down tight enough to compress the blanket---take all the air out of it. The purpose of the presser foot is to hold the fabric down so when the needle comes up, it holds the fabric down...no flagging. 3. Auto tension should work just fine. 4. Be sure your bobbin tension is set so you have to give a snap with your wrist to get the bobbin to drop 5-6 inches. Amayas like a bobbin set just a bit tight. 5. Be sure you have good, sharp needles in and not turned to the left AT ALL. Check this by using a magnifying glass and look at the groove down the front of the needle. Either straight forward or 5-10 degrees to the right. 6. BE SURE you have lubed your machine and the bobbin area is free of all lint and dust. Also clean out from under your leaf spring on the bobbin case with the corner of a piece of paper. Hope these suggestions help. Sharon Sharon =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================