TOM The Grabber blade doesn't trim or cut the thread. The Moveable Knife, located under the needle plate actually cuts the thread, and the grabber blade then swings back and pushes the cut thread out of the garment into the Grabber bracket where the Velcro strips hold it in place until that needle is ready to sew again. The grinding sound that you are hearing is because the thread is not being cut by the moveable knife so when the grabber blade swings back it can't travel the full distance that it needs to and the motor starts to,,,,,, (Complain). Check your knife to see if there are any burrs or scratches on the cutting surface, and also check to see that the knife actuals fires. Also your retaining finger may not be adjusted properly causing the knife to miss the loop. If your needles are turned to far to the right, they may also cause missed trims on occasion. If your not sure how to check or adjust any of these items feel free to call me at 301-471-3157 Hugo Torbidoni Melco Tech ************************************** See what's free at http://www.aol.com. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================