This message was posted by KIDSPORT on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/2/650.html Hello everyone, A customer gave us a dst file of his logo to embroider. The problem we're having is that we can't get the design to trim between elements or letters. There is a lot of small lettering that needs trimming and its impossible to do it by hand. I tried saving the file as an ofm and adjusted the "trim if less than" setting but no luck. Any suggestions? Thanks, Chris =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================