This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1389.html#000001 Need more info on what you have done before this happened. It appears that you have had to remove the black plastic upper arm cover on the right side. Is that correct? If so, did you have the machine all the way over to the # 1 position? Did you allow the needlecase to move without the black plastic upper arm cover in place? And is it back in place now? Can you rotate the Z-axis shaft by hand 360 degrees? Make sure the the E-stop is depressed if the machine is on...Does the # 1 needle raise and lower while turning the E-shaft by hand a full 360 degrees? If the cover is off, replace it BEFORE releasing the E-stop!! Have you tried going into "Maintenance" "Head timing" in AOS and left clicking on head-up? Rod Springer Amaya Tech & Trainer =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================