Greetings, My systems are both WindowsXP home, one has Jaws V10 the other Jaws V11. I have installed GoldWave V5.67 which, so far as I am aware is the latest available, I have also installed the latest Jaws scripts. I note in the new versjion of GoldWave, there is a change to how a file is recorded. If f9 is pressed, a new file is opened and recording commences immediately, this uses whatever parameters are set for default, but if the parameters are set in control properties, a new file started using f9 will be the specified time in these properties. The old form of ctrl+f9 is now spare, according to the keyboard, which I saved under options and keyboard, this also now contains a new item, called record selection, which is unassigned. I decided, therefore, ti assign ctrl+f9 to this function, closed GoldWave, reopened it and loaded the amended keyboard in. I then created a new file using the usual ctrl+n which was created no problems. I assumed, therefore, in effect, this would be a selection so tried recording via the ctrl+n command as in the past and nothing recorded. I tried opening an existing file the start of which I wished to replace, moving start and end markers as necessary leaving 8 minutes to be replaced, on starting ctrl+f9 still nothing was recorded. Can anybody tell me am I missing something, or is it now necessary when needing to insert or overwrite, the material must be created in a new file then pasted into/over the existing? If so, in my view this is a retrograde step and I shall revert to my tried-and-tested version 5.58 which does exactly what I wish. I have written to the author, I have also checked the frequently asked questions and the help informmation in the program, I have not, as yet, checked the manual. I did find on the site ctrl+f9 is still given as the start recording keystroke, so it would seem the site has yet to be updated. Colin Howard, living near Southampton in Southern England. ** To leave the list, click on the immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** access-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq