Ciao a tutti. A causa del pochissimo tempo a disposizione mi ero dimenticato di postare questo stralcio di una email di Ben Versteeg (autore della PC Keyboard Interface per il beneamato Speccy) che potrebbe risultare utile per risolvere i problemi di clock del 128K heatsink e, forse, per induzione, anche quelli dell'ISSUE6A. ------------------------------------------------------------------------------------------------------------ One of the reasons that the clock signal of the ZX Spectrum 128K heatsink model might be so bad, may be wrongfully used transistors. There are three transistors (all 2N3904) that somehow are soldered 180 degrees wrong. They are soldered as the silk screen shows, but I think someone at Sinclair has used a wrong datasheet. I say that because there are some wrong and some other unclear datasheets found while Googling, so it's very easy to make this mistake. By turning around these three transistors, the picture get's better, the clock signal is better, and some other signal is better, have to look that up. So maybe that's why the 128K has such a bad clock signal by default. I still have to check this with an oscilloscope. ------------------------------------------------------------------------------------------------------------ Non ho idea di quali siano i transistor corrispondenti sull'ISSUE6A ma il buon Alessandro sicuramente lo sa :-) Nel frattempo ho acquistato un altro ISSUE6A che si comporta ancora peggio di quello attualmente sotto test a casa Poppi; questo, con collegata la ZXMMC+, non si avvia proprio mai. Se vuoi ti invio anche questo; non ti serve nemmeno lo stress test per mandarlo in crisi :-) Ciao! Eugenio