Hi Guys,
During the last month I've been designing al alternative enclosure for
the ZX harlequin.
Made up of three pieces:
- Base
- Rear cover
- Front Cover (where the rubber mat, membrane and faceplate will go)
I have the base done. Now I'm working on the rear cover part.
Then I'll leave the front cover section, will be the trickiest one.
The idea is to be able to print without support material, to be robust
and cheap to print. 6 Euros considering the cost of PLA filament and KW
of electricity in Spain.
https://www.thingiverse.com/thing:2962998
Regards.