Are these devices using the USB class driver? What form factor do they show up as (speakers, microphone, headset, etc.)? Thanks. From: wdmaudiodev-bounce@xxxxxxxxxxxxx [mailto:wdmaudiodev-bounce@xxxxxxxxxxxxx] On Behalf Of Victor Zhodzishsky Sent: Friday, April 27, 2007 9:31 AM To: wdmaudiodev@xxxxxxxxxxxxx Subject: [wdmaudiodev] Re: Preffered audio device does not switch Hi Mitch, Thanks for the quick answer, but that is not what we observed. We were plugging devices with cpl off. After plugin the cpl reliably shows original device as being default. We tried to plug in 3 different types audio devices which were supposed to switch the default with the same result. WMP reliably plays into original default device and all system sounds for example volume slider tone goes to the new device. We reinstalled the image several times and result was consistent. Obviously something is screwed up in the image, but I have no idea where to look at. Thanks, Victor From: wdmaudiodev-bounce@xxxxxxxxxxxxx [mailto:wdmaudiodev-bounce@xxxxxxxxxxxxx] On Behalf Of Mitchell Rundle Sent: Friday, April 27, 2007 11:02 AM To: wdmaudiodev@xxxxxxxxxxxxx Subject: [wdmaudiodev] Re: Preffered audio device does not switch Is mmsys.cpl running when you plug the USB device in? Mmsys.cpl should indicate the default change immediately, but I do have a bug report that says it sometimes (very rarely) doesn't. Restarting mmsys.cpl should fix it. For WMP to use the new device you need to restart WMP, or just play a new song. E.g. if you are listening to an album, it will use the new default when the next song starts. Regards, Mitch From: wdmaudiodev-bounce@xxxxxxxxxxxxx [mailto:wdmaudiodev-bounce@xxxxxxxxxxxxx] On Behalf Of Victor Zhodzishsky Sent: Friday, April 27, 2007 4:47 AM To: wdmaudiodev@xxxxxxxxxxxxx Subject: [wdmaudiodev] Preffered audio device does not switch We have a Vista platform where audio system behaves quite funny. When you plug in a device which supposed to become a default playback (for ex. USB speaker), all system sounds are directed to the new device. However control panel still shows previous device as the default, and output from the media player is also directed to the previous default device. Any suggestions on how to debug this would be appreciated. -Victor