Hello ,Sam Saturday, June 19, 2004, 3:05:29 PM, you wrote: ST> Oh, sorry. You must call the function *before* you connect the pins. ST> It is strange, but it is so. ST> Try that...and tell me if it works. So as I do. I call the SuggestAllocatorProperties function before connecting pins. Reread my post ;) ST> -----Original Message----- ST> From: wdmaudiodev-bounce@xxxxxxxxxxxxx ST> [mailto:wdmaudiodev-bounce@xxxxxxxxxxxxx] On Behalf Of Yura ST> Sent: Saturday, June 19, 2004 5:09 AM ST> To: Sam Tertzakian ST> Subject: [wdmaudiodev] Re: MSVAD and WDM capture ST> Hello ,Sam ST> Tuesday, June 15, 2004, 5:40:31 AM, you wrote: ST> Thank you so much for the answer! ST> I tried what you suggested, but have some problems again. ST> When I call SuggestAllocatorProperties(before the pin is connected), ST> it returns SUCCESS. Then I connect the pin and call ST> GetAllocatorProperties but it returns E_FAIL. When I run the graph I ST> see that KsProxy ignored my previous ST> SuggestAllocatorProperties call. ST> Then I used debugger to find allocator properties in memory and to change ST> them. When I did this, the sound became perfect!!!(Only until I restart the ST> graph of course). ST> So here is my new question. Can I change the default allocator ST> properties that KsProxy uses from my driver? Or what else I need to do ST> to change them from User-mode? ST> Thanks! -- Best regards, Yura mailto:spirit@xxxxxxxxxx ****************** WDMAUDIODEV addresses: Post message: mailto:wdmaudiodev@xxxxxxxxxxxxx Subscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=subscribe Unsubscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=unsubscribe Moderator: mailto:wdmaudiodev-moderators@xxxxxxxxxxxxx URL to WDMAUDIODEV page: http://www.wdmaudiodev.de/