[wdmaudiodev] Device install for a msvad-like device

  • From: "Robert Bielik" <robert.bielik@xxxxxxx>
  • To: wdmaudiodev@xxxxxxxxxxxxx
  • Date: Thu, 09 Feb 2006 14:25:49 +0100

I'm trying to use the DIFxAPI to install a msvad-class device (software only), 
but I can't figure out how to make it work. With an added [DefaultInstall] 
section in the .inf file I could make the test application install the driver 
files (.inf+.sys), BUT it doesn't seem to start the device! I.e. I cannot see 
the device in control panel. 

During development, I use devcon for installation/uninstallation, and I get the 
same behavior there (almost), namely that devcon install <inf-file> <hwID> 
installs the driver, but I need to do devcon enable <hwID> to actually startup 
the device (it is always in stopped mode after install).

Any ideas here, cause I'm loosing hair over this. The little I have left that 



WDMAUDIODEV addresses:
Post message: mailto:wdmaudiodev@xxxxxxxxxxxxx
Subscribe:    mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=subscribe
Unsubscribe:  mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=unsubscribe
Moderator:    mailto:wdmaudiodev-moderators@xxxxxxxxxxxxx


Other related posts:

  • » [wdmaudiodev] Device install for a msvad-like device