[vip_students] Re: problem opening outloook

  • From: "Flor Lynch" <florlync@xxxxxx>
  • To: <vip_students@xxxxxxxxxxxxx>
  • Date: Sat, 14 Nov 2009 13:33:09 -0000

Perhaps it's just AVG doing its thing? Can you launch Microsoft Outlook just by opening it normally?


----- Original Message ----- From: "Edel Carey" <careyedel@xxxxxxxxxx>
To: <vip_students@xxxxxxxxxxxxx>
Sent: Saturday, November 14, 2009 11:20 AM
Subject: [vip_students] Re: problem opening outloook


Thanks for that information I changed my settings successfully. Not sure what has happened to my outlook though. I'm not too bothered now that I've fixed the settings as I find that visually outlook express is superior to outlook

Edel..
----- Original Message -----
From: "Flor Lynch" <florlync@xxxxxx>
To: <vip_students@xxxxxxxxxxxxx>
Sent: Friday, November 13, 2009 10:48 PM
Subject: [vip_students] Re: problem opening outloook


Edel,

If email addresses from the Web are 'assigned to outlook,' you can change that by going into:

-- Control Panel, or internet Explorer Tools, - internet Options;
-- Now shift+tab and then right-arrow to the programs Tab;
-- Then press the tab key a few times until you come to the email combo box, and then arrow to highlight Outlook Express.
-- Tab to and press enter on OK.

there may (or may not) be something wrong in your microsoft outlook. but make sure that it is closed so that the change as above will take effect.

----- Original Message ----- From: "Edel Carey" <careyedel@xxxxxxxxxx>
To: <vip_students@xxxxxxxxxxxxx>
Sent: Friday, November 13, 2009 3:28 PM
Subject: [vip_students] problem opening outloook


Hi again everyone

I use outlook express as my preferred email programme but I'm trying to access email addresses on a web page and I assume they are assigned to outlook but mine won't open. I keep getting avast flashing up for a second on the screen followed by the following message.

Cannot start Microsoft outlook. The .DLL file for the information service could not be found. MAP1 was unable to load the information service PSTPR.DLL. Be sure the service is correctly installed and configured.

Any advice would be much appreciated.

Edel..






Other related posts: