[usbca_chess] RE: [usbca_chess] chess set modification - Re: [usbca_chess] Hadley chess set, some pieces don’t fit

  • From: "JT" <hazelnutt2001@xxxxxxxxx>
  • To: <usbca_chess@xxxxxxxxxxxxx>
  • Date: Tue, 14 Jan 2020 11:27:27 -0600

I may have to try that. I’m dubious as to how strong a magnetic hold you can 
get. Most of the game store magnetics I’ve looked at have been too weak to 
handle anything but a very light touch. In fact, Chessbaron’s first venture 
into producing a magnetic chess set resulted in that very problem. The magnetic 
hold was good enough to keep the pieces standing, but only if the touch was 
light. But I’ll take another look.

Jim T

 

From: usbca_chess-bounce@xxxxxxxxxxxxx 
[mailto:usbca_chess-bounce@xxxxxxxxxxxxx] On Behalf Of Charles Rivard
Sent: Tuesday, January 14, 2020 8:26 AM
To: usbca_chess@xxxxxxxxxxxxx
Subject: [usbca_chess] chess set modification - Re: [usbca_chess] Hadley chess 
set, some pieces don’t fit

 

I have modified chess sets in the past, and all it takes is a few dollars and 
careful work.  Here’s how, basically:  Go to a game store and find a set you 
like.  Then, get a glue that will dry to form a hard surface and place a drop 
of it somewhere on each black piece so that it can easily be identified and let 
them dry.  Now for the board:  At any hobby or craft store, you can buy rolls 
of strip magnet that have adhesive backing.  Find a roll that is just about the 
width of the squares on your board.  Cut the strips into squares.  With a 
brailled ruler, or with one square that someone cuts for you as a guide, stick 
a square of magnet on a corner square and press.  Cover the board with these, 
then add a second magnet to each black square ti give raised squares.  Also 
stick a square of magnet to the bottom of each chess piece.  You will never 
have to worry about loose fitting peg board sets again, and you will get a set 
that you like without much cost.

 


If you think you're finished, you! really! are! finished!!

 

From: Din Din (Redacted sender  <mailto:dmarc-noreply@xxxxxxxxxxxxx> "dinner42" 
for DMARC) 

Sent: Sunday, January 12, 2020 10:34 PM

To: USBCA <mailto:USBCA_chess@xxxxxxxxxxxxx>  

Subject: [usbca_chess] Hadley chess set, some pieces don’t fit

 

Hi,

 

I have a chess set from Hadley. It's about ten years old. There has never been 
a snug fit between some of the board's holes and some of the pieces. In some 
cases, the holes are too big -- no piece fits snugly. In other cases, the base 
of some pieces are too small -- these pieces don't fit snugly into any hole.

 

I haven't tried filling in the "too large" holes. I've tried wrapping tape 
around the base of the "too small" pieces, but the tape doesn't stick for very 
long.

 

Any suggestions on how to fix this problem would be appreciated. It's one of 
the main reasons I keep losing interest in chess.

 

Thanks,

Dan

 

Sent from my rotary phone. 

 

Other related posts:

  • » [usbca_chess] RE: [usbca_chess] chess set modification - Re: [usbca_chess] Hadley chess set, some pieces don’t fit - JT