[THIN] Re: oki printer c5600 vs c5900
- From: David <dmauri@xxxxxxxxx>
- To: thin@xxxxxxxxxxxxx
- Date: Thu, 29 Mar 2007 16:53:08 +0200
Greg Reese escribió:
in my past experience with Oki, i found that PS support was not always
included but PCL usually is. You can also run them as an HP. Try
popping a HP Color LaserJet 4500 driver on the 5600 and see if your
printing improves. I always had real good results from Oki. They
were cheap, tough, and dependable.
On 3/29/07, *David* <dmauri@xxxxxxxxx <mailto:dmauri@xxxxxxxxx>> wrote:
Hi all,
be noticed of my own fault....
We have bought a Oki printer (laser & color) model c5600 time ago.
And now we have notice that a simple job such as pdf file about 1mb,
take aprox. 90mb to create the spool.
I called to techcnical service and they said that is 'normal'..because
is Winprint not PS/PCL.....
So, now we are going to buy new one, OKI C5900N.
Anyboy has this one? to avoid the same problem, despite of I know is
PCL supported.
Thanks a lot.
SBC SITES ONLY GOOGLE SEARCH: http://www.F1U.com
************************************************
For Archives, RSS, to Unsubscribe, Subscribe or
set Digest or Vacation mode use the below link:
//www.freelists.org/list/thin
************************************************
No, If I change the driver then it doesn't work.
It only works with its own driver, at least, for my experience.
Perhaps, I must change the port? or something like that?
SBC SITES ONLY GOOGLE SEARCH: http://www.F1U.com
************************************************
For Archives, RSS, to Unsubscribe, Subscribe or
set Digest or Vacation mode use the below link:
//www.freelists.org/list/thin
************************************************
Other related posts:
