I've been confused about the wording for the SLR thresholds: o High latency threshold: Specify a threshold value above which SpeedScreen options should be enabled. o Low latency threshold: Specify a threshold value below which SpeedScreen options should be disabled. So, does that mean if I set a 150 low and a 500 high that it's only enabled for > 500? What's the point of the low specification, then? Or, is the wording screwed up and it is actually enabled between 150 and 500? Thanks, Roger Riggins Network Administrator Lutheran Services in Iowa w: 319.859.3543 c: 319.290.5687 http://www.lsiowa.org <b>Lutheran Services in Iowa Confidentiality Notice:</b><br> <red>The information contained in this communication may be confidential, is intended only for the use of the recipient(s) named above, and may be legally privileged. If the reader of this message is not the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this communication, or any of its contents, is strictly prohibited. If you have received this communication in error, please return it to the sender immediately and delete the original message and any copy of it from your computer system. If you have any questions concerning this message, please contact the sender.</red>