Hi, I currently run Access Gateway 2010 with 4.6.1 appliance with the management taking place on an Advanced Access Gateway to control access check security, AV etc. and have multiple logon points. My main reason for the upgrade is to provide redundancy in case of a failure. Should I be going with the new Access Gateway 5 and if so does this make the Advanced Access Control redundant. I have just started my reading and it's looking that way. I have also seen posts to stay away from the newer version but these can often be red herrings. Has anyone adopted it and if so is there anything I should be taking into consideration? Thanks Ronnie Ronnie Hamilton Senior Network Engineer Lufthansa Technik Airmotive Ireland IT Department Naas Road, Rathcoole Co. Dublin, Ireland Phone: +353 1 401 1253 E-mail: ronnie.hamilton@xxxxxxx <mailto:ronnie.hamilton@xxxxxxx> www.ltai.ie Visit our website : www.ltai.ie __________________________________________ Lufthansa Technik Airmotive Ireland Limited. Registered in Ireland. Reg. No. 45999. Registered Office: Naas Road, Rathcoole, Co.Dublin. Lufthansa Technik Airmotive Ireland Leasing Limited. Registered in Ireland. Reg. No. 140891. Registered Office: Naas Road, Rathcoole, Co.Dublin. __________________________________________ The information in this email and in any attachments is confidential and may be privileged. If you are not the intended recipient, please destroy this message, delete any copies held on your systems and notify the sender by return email. You should not read, retain, copy, disseminate, distribute, disclose or use this email or its contents in any way. Any such action is strictly prohibited. Thank you.