Hi, Slightly OT but with the upgrade to XenApp 6.5 on 64 bit servers I am building a 64 bit print server, which will enable users on 32 bit desktops to use 32 bit driver and when on XenApp use 64 bit drivers. Mostly going OK but I have some v old HP printers that use the Laser Jet 4050 driver, HP recommends to use the UPD when printing on 64 bit. This is fine is I use the 32 bit UPD on the 4050's but I have the UPD was tested a while back and there were enough issues to keep using the native driver. As the driver name doesn't match I cannot use the native 32 bit driver and the 64 bit native driver on the same queue. Is there any way round this other than creating a 32 bit and 64 bit queue. Thanks Ronne Ronnie Hamilton Senior Network Engineer CCEE Lufthansa Technik Airmotive Ireland IT Department Naas Road, Rathcoole Co. Dublin, Ireland Phone: +353 1 401 1253 E-mail: ronnie.hamilton@xxxxxxx <mailto:ronnie.hamilton@xxxxxxx> www.ltai.ie <http://www.ltai.ie> Visit our website : www.ltai.ie __________________________________________ Lufthansa Technik Airmotive Ireland Limited. Registered in Ireland. Reg. No. 45999. Registered Office: Naas Road, Rathcoole, Co.Dublin. Lufthansa Technik Airmotive Ireland Leasing Limited. Registered in Ireland. Reg. No. 140891. Registered Office: Naas Road, Rathcoole, Co.Dublin. __________________________________________ The information in this email and in any attachments is confidential and may be privileged. If you are not the intended recipient, please destroy this message, delete any copies held on your systems and notify the sender by return email. You should not read, retain, copy, disseminate, distribute, disclose or use this email or its contents in any way. Any such action is strictly prohibited. Thank you.