Hi All I have a Thin client on a remote site. There is network printer on the site and the site is connected to head office through a site to site vpn. The printer is setup on the head office print server as a Shared local printer with a standard TCP/IP port. The printer is setup on the citrix servers as a local printer with a local port of \\servername\printshare . From time to time when the client prints from citrix to the site printer the print job starts to spool and reaches 75% of the total print job....meanwhile the print job may have printed 3 of 4 pages. The print job fails to reach 100% and begins to spool again thus printing 3 of 4 pages again. This cycle continues until I cancel the print job from the main print server. Any Ideas Regards Tom Flanagan IT DORIC Constructions (Australia) Pty Ltd ACN 99 080 922 498 1st Floor 420 Hay Street PO Box 451 Subiaco WA 6008 Telephone (08) 9388 2655 Facsimile - 9388 1484 E-Mail address - tflanagan@xxxxxxxxxxxxxxxxx Disclaimer: The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. If you are not the intended recipient of this message you are hereby notified that any use, review, retransmission, dissemination, distribution, reproduction or any action taken in reliance upon this message is prohibited. If you have received this email in error, please notify us immediately by return e-mail or telephone +61 8 9388 2655 and destroy the original message. Any views expressed in this message are those of the individual sender and may not necessarily reflect the views of the company. SBC SITES ONLY GOOGLE SEARCH: http://www.F1U.com ************************************************ For Archives, RSS, to Unsubscribe, Subscribe or set Digest or Vacation mode use the below link: //www.freelists.org/list/thin ************************************************