[THIN] Re: NT4.0 TSE install scsi problems - HELP Urgent- Weekend rebuild

  • From: "Jim Kenzig http://thethin.net" <jimkenz@xxxxxxxxxxxxxx>
  • To: <thin@xxxxxxxxxxxxx>
  • Date: Fri, 14 Mar 2003 23:06:03 -0500

Sounds like NT is already detecting the drives and you don't need to add the
scsi drivers doesn't it? Did you try going through the install without that
step?
JK

-----Original Message-----
From: thin-bounce@xxxxxxxxxxxxx [mailto:thin-bounce@xxxxxxxxxxxxx]On
Behalf Of Tom Flanagan
Sent: Friday, March 14, 2003 10:51 PM
To: 'Thin (E-mail)
Subject: [THIN] NT4.0 TSE install scsi problems - HELP Urgent- Weekend
rebuild


Hi Everyone

Got a problem here.  I am reinstalling NT 4.0 tse onto newer hard drivers.
18GB scsi. (old ones were 9.0GBSCSI). I am using an NT 4.0 TSE sp3 install
CD_rom.

When I get to the section where it says press S to specify another Mass
storage device and put in your manufacturer diskette.  I do this.
I select the Adaptec ultra 160 Scsi device and proceed.  ref: (My ScSi card
at boot up says AIC 7899)

Next the install tells me it cannot see any hard drives. The hardrive are
detected at startup though?

Is this because the HDD are too big.  Do I need to get hold of a NT4.0 TSE
intall disk bundled with a later SPack?  HELP? PLEASE

Regards

Tom Flanagan
IT Network Administrator
Kailis & France Foods
Ph: +61 8 9273 6281
Mob: 0408 927 247
email: tom.flanagan@kailis-france.

*********************************************************
This Week's Sponsor - RTO Software / TScale
TScale increases terminal server capacity. 
Get 30-40% more users per server to save $$$ and time. 
Add users now! - not more servers. If you're using Citrix, 
you must learn about TScale!  Free 30-day eval:
http://www.rtosoft.com/Enter.asp?ID=79
**********************************************************

For Archives, to Unsubscribe, Subscribe or 
set Digest or Vacation mode use the below link:
http://thethin.net/citrixlist.cfm

Other related posts: