Thanks I found the thread. It doesn't really state if it's MF XP or MPS. Have you tried it with MPS 3.0? Thanks, Jobe Gates Supervisor of Network Systems Genesys PHO 810-424-2310 Phone 810-743-1099 Fax jgates@xxxxxxxxxxxxxx CONFIDENTIALITY NOTICE: This email transmission may contain confidential information. This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to which it is addressed. If you have received this email in error, please immediately notify the sender by email at the address shown and permanently delete this message from your email files. "Landin, Mark" <Mark.Landin@xxxxxxxxxxxxxxxx> Sent by: thin-bounce@xxxxxxxxxxxxx 11/10/2004 09:41 AM Please respond to thin To: thin@xxxxxxxxxxxxx cc: Subject: [THIN] Re: Ghost MPS 3.0? I have, but so far only restored it back to the same machine. Sometime next week I'm going to practice cloning it to a new machine. List participant Phil Newman had this to say about Ghosting Metaframe, and it's my basic plan of action: "We use ghost for all out servers - the only modification we do is to delete the WSID out of the MF20.DSN file, and set the IMA Service to disabled before running SYSPREP. The server is then ghosted, and oncew the image has been installed - the correct WSID, in entered into the MF20.DSN file, and IMA Service started regards, Phil Newman" From: thin-bounce@xxxxxxxxxxxxx [mailto:thin-bounce@xxxxxxxxxxxxx] On Behalf Of jgates@xxxxxxxxxxxxxx Sent: Wednesday, November 10, 2004 7:17 AM To: thin@xxxxxxxxxxxxx Subject: [THIN] Ghost MPS 3.0? Has anyone successfully ghosted a MPS 3.0 on W2K3? I was looking in the archive and didn't see much about it. Thanks, Jobe