I have them set to disconnect on a time out or broken connection. I then have the disconnect set to 1 minutes. Yet they still remain in an active state if the lose power or just shut down the PC. I will continue to test the new client, but it seems to do the trick. -----Original Message----- From: Ron Oglesby [mailto:roglesby@xxxxxxxxxxxx] Sent: Tuesday, July 02, 2002 6:43 PM To: thin@xxxxxxxxxxxxx Subject: [THIN] Re: Connections not dropping... How about reseting them or disconnecting them. -----Original Message----- From: Schneider, Chad M. [mailto:CMSchneider@xxxxxxxxx] Sent: Tuesday, July 02, 2002 2:32 PM To: 'thin@xxxxxxxxxxxxx' Subject: [THIN] Connections not dropping... I have been fighting this, with no luck. Users running through NFUSE, a remote site lost power. Now that is back up, no one can get back into their programs, as their sessions remained in a active state, rather than going to disconnect. Thoughts? Chad M. Schneider Technology Analyst II Curwood, Inc. Phone: 920-303-7609 Pager: 920-909-7609 =================================== For Archives, to Unsubscribe, Subscribe or set Digest or Vacation mode use the below link. http://thethin.net/citrixlist.cfm =================================== For Archives, to Unsubscribe, Subscribe or set Digest or Vacation mode use the below link. http://thethin.net/citrixlist.cfm =================================== For Archives, to Unsubscribe, Subscribe or set Digest or Vacation mode use the below link. http://thethin.net/citrixlist.cfm