[THIN] Re: AAC console does not show AG server
- From: "Hutchinson, Alan" <Alan.Hutchinson@xxxxxxxxxxxxxxxxxx>
- To: <thin@xxxxxxxxxxxxx>
- Date: Fri, 13 Jan 2006 14:14:10 -0000
Number of appliances should show as the IP address of the CAG - I'm sort
of guessing that you don't have two-way communication between these two
devices. You should NOT be able to see any AAC pages on the CAG. As per
an earlier e-mail (different thread) when set up, the AAC "sucks" all
the pages from the CAG. When the two are communicating correctly the
only page you see on the CAG is the main setup page (Access Gateway
Cluster) - all other tabs are greyed out on the CAG. I seem to remember
having to open ports 9001, 9002, 9003, 9004, and 9005 - for the two to
communicate properly. We haven't yet tried the Secure Server
Communication checkbox on the CAG etc.
Regards,
Alan.
_____
From: thin-bounce@xxxxxxxxxxxxx [mailto:thin-bounce@xxxxxxxxxxxxx] On
Behalf Of Matthew Shrewsbury
Sent: 12 January 2006 19:39
To: thin@xxxxxxxxxxxxx
Subject: [THIN] Re: AAC console does not show AG server
Not that I am aware of. I just checked the Citrix site and none are
listed under AG 4.2 and AAC 4.2. Do you know of one?
Matthew Shrewsbury, MCSE+Internet MCSE 2000 CCA Server+
Senior Network Administrator
-----Original Message-----
From: thin-bounce@xxxxxxxxxxxxx [mailto:thin-bounce@xxxxxxxxxxxxx] On
Behalf Of Ruben Spruijt
Sent: Thursday, January 12, 2006 1:33 PM
To: thin@xxxxxxxxxxxxx
Subject: [THIN] Re: AAC console does not show AG server
Hi,
Is a hotfix not needed for the ASC ?
Ruben
_____
From: thin-bounce@xxxxxxxxxxxxx [mailto:thin-bounce@xxxxxxxxxxxxx] On
Behalf Of Matthew Shrewsbury
Sent: Thursday, January 12, 2006 8:00 PM
To: thin@xxxxxxxxxxxxx
Subject: [THIN] AAC console does not show AG server
I have my eval AG pointed to my AAC server and they seem to work
although I am having some issues (most likely me doing something wrong).
However I noticed in the AAC management console shows a node called
"Gateway Appliances" and under that node it shows "# of appliances 0".
Is this normal? I have run discovery many times and it never finds the
AG. It however does seem to work in that I can log into the AG and
receive AAC webpages.
I read on a Citrix forum that you can check in the SQL server under
"AccessGateway" table you should see an entry for the AG which in my
case does not appear. The AccessGateway table is blank for me. Should I
be concerned about this?
I can ping the AG from the AAC server and there is no firewall between
them. I am only using a single NIC on the AG (NIC 0). Any help would be
great as I am running out of eval time...
Matthew Shrewsbury, MCSE+Internet MCSE 2000 CCA Server+
Senior Network Administrator
Other related posts:
