look for burned 1 ohm resistors and bad STK ic's on the convergence board it's the one mounted to side wall of box Robert tvservice@xxxxxxxxxxxxxxxxxxx H & H Electronics Inc ----- Original Message ----- From: "joel e sanford" <jo-rope@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, November 20, 2002 11:33 AM Subject: [TechAssist] zenith Z46Z83D > > > joel sanford > senior tech > chicago illinois 60628 > dba SPEEDY ELECT> > > I have in for repair a zenith projo That had the heavy burn smell !I saw > that it was CRX3412....and since I did not want to take eny chanches I > sent the 9-1674 mod in for repair.every thing came up OK(restored raster > and vidio) but I cannot get the red and green to converge! there are no > ajustments or convergance controls(I took the box out)on the crosshatch > the red is away at a forty five degree angle, there is no magnetisim > around and no ajusytment on the yoke. eny suggestion on this? emy help > will be appreciated. Sanford > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/