On a KV32HSR10,I recently repaired with your sympton;check/replace the following: Q505,R571,R518......Don... HARTS-TVCR''ASC'' 9 Robert St.,Oromocto,NewBrunswick,Can E2V 3N2 Tel#506-357-9785,Fax#506-357-6010 hartstv@xxxxxxxxxxx ----- Original Message ----- From: "joel e sanford" <jo-rope@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, October 11, 2002 1:58 PM Subject: [TechAssist] sony KV-27EXR95 > > > joel sanford > senior tech > chicago illinois 60628 > dba SPEEDY ELECT> > > joel sanford > senior tech > chicago illinois 60628 > dba SPEEDY ELECT> > > > I have a sony in for service symptons were dead due to surge! I > had a print of the G-board from a close set... and was able to get the > set up and running( replaced IC6521 strs6301 and Q612 a couple of caps > that were borderline and resolder D622 ) Now the problem is that the > raster is bowed on both sides, and I am not sure where to look . does > enyone have a print or a hint as to where to look?bow is about one an a > half inches on both sides. since it changes with picture scenes I am > wondering if it is still on the G-board(reg/conv) > sanford > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/