[TechAssist] Re: rca p60152 ptk169ptc conv problem
- From: "Damon" <DAMON101@xxxxxxxxxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Wed, 1 May 2002 21:27:43 -0500
Well, there has been a few convergence output transistors that have shorted
and smoked their respective resistors. But if you are staring at the
convergence board, take a few minutes to flick your eyeballs upwards and
stare at the board's connectors, because there was a bulletin out about
corrosion affecting the plugs and connectors. It caused the convergence to
drift and bend. They had a replacement kit out for that.
Damon Brunger
damon101@xxxxxxxxxxxxxx
Telrad Electronic Services
Ft Wayne, IN 46815
----- Original Message -----
From: "repair1" <repair1@xxxxxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Wednesday, May 01, 2002 12:01 PM
Subject: [TechAssist] rca p60152 ptk169ptc conv problem
>
> This set is in customer's home(upstairs of course) from what customer
> describes conv is off on sides about a third of way in on each side, cust
> says crosshatch looks perfect. First of all, this hard to believe but I
have
> never had a single conv failure in the couple of hundred I have repaired,
> secondly I am hesitant about just pulling light box, because I would not
be
> able to see most conv problems with my setup at shop, any help would be
> greatly appreciated.
>
> charlers betzler
> Best Electronics
> repair1@xxxxxxxxxxxxx
>
> ------------------------------------------
> To REMOVE your email address, click here:
> http://www.tech-assist.org/unsubb.html
> ------------------------------------------
> ***NEW*** Tips Added Instantly!!!***
> Submit Repair Tips here:
> http://www.tech-assist.org/secure/tip/
>
------------------------------------------
To REMOVE your email address, click here:
http://www.tech-assist.org/unsubb.html
------------------------------------------
***NEW*** Tips Added Instantly!!!***
Submit Repair Tips here:
http://www.tech-assist.org/secure/tip/
Other related posts:
