[TechAssist] Re: pt-51g36ce convergence

  • From: Manuel Reyes <reyes9159@xxxxxxxxxxxxx>
  • To: techassist@xxxxxxxxxxxxx
  • Date: Wed, 4 Jan 2006 17:11:30 -0800 (PST)

can you send me a copy too if you don't mind Billy
thanks : Manuel

--- D Trippel <dtrippel@xxxxxxxxxxx> wrote:

> Hello
> I lifted all 2.2 ohm resistors and they check ok. I
> would really 
> appreciate the service manual . Thanks!!
> Don
> >Don, might recheck R7010,7014,7019,7024,7028,7032,
> lift one end, all  2.2ohm J 2watt. If you still need
> S.M.,Schem. about 11 Mb., let me know ,can email..
> >   
> >  Bill
> >    Bill'sTV
> >      Sonora,Calif.
> >  
> >D Trippel <dtrippel@xxxxxxxxxxx> wrote:
> >  Hello
> >I tried that, will not go into diagnostic mode.
> Thanks
> >  
> >
> >>try pushing "action" and "power" at the same time
> set
> >>will shut off and come back on by itself in the
> >>diagnostic mode ,then shut off set, should reset
> to
> >>original factory settings.sometimes this brings
> the
> >>convergance back close 
> >>
> >>Jerry Wilkinson
> >>Scotty's TV Service
> >>Livonia Mi 48152
> >>
> >>--- D Trippel 
> >>    
> >>
> >wrote:
> >  
> >
> >>
> >>    
> >>
> >>>Unfortunately I don't have the service manual for
> >>>this set,I have asked 
> >>>if anyone had the manual but no reply. I guess i
> am
> >>>kind of screwed. I 
> >>>will try and buy one some place. All I can do is
> >>>access the customer 
> >>>convergence so I really can't tell.
> >>>
> >>>
> >>>      
> >>>
> >>>>I was wondering, because we seem to be having
> >>>>
> >>>>
> >>>>        
> >>>>
> >>>similar problems.
> >>>
> >>>
> >>>      
> >>>
> >>>>If it's digital convergence, can you get any
> >>>>
> >>>>
> >>>>        
> >>>>
> >>>movement within set-up?
> >>>
> >>>
> >>>      
> >>>
> >>>>-Ed-
> >>>>Tel-Tek Electronics
> >>>>Ontario-Canada
> >>>>
> >>>>teltek3@xxxxxxxxxxxx
> >>>>
> >>>>"Seasons Greetings"
> >>>>----- Original Message -----
> >>>>From: "D Trippel" 
> >>>>        
> >>>>
> >
> >  
> >
> >>>>To: 
> >>>>Sent: Wednesday, January 04, 2006 1:19 PM
> >>>>Subject: [TechAssist] Re: pt-51g36ce convergence
> >>>>
> >>>>
> >>>>
> >>>>
> >>>>
> >>>>
> >>>>        
> >>>>
> >>>>>Hello
> >>>>>No this is a Panasonic,But those stks are used
> in
> >>>>>
> >>>>>
> >>>>>          
> >>>>>
> >>>a lot of sets
> >>>
> >>>
> >>>      
> >>>
> >>>>>
> >>>>>
> >>>>>          
> >>>>>
> >>>>>>Don;
> >>>>>>Is that a Toshiba?
> >>>>>>Those STK392-110 sound strangely familiar.;-)
> >>>>>>
> >>>>>>-Ed-
> >>>>>>Tel-Tek Electronics
> >>>>>>Ontario-Canada
> >>>>>>
> >>>>>>teltek3@xxxxxxxxxxxx
> >>>>>>
> >>>>>>"Seasons Greetings"
> >>>>>>----- Original Message -----
> >>>>>>From: "D Trippel" 
> >>>>>>            
> >>>>>>
> >
> >  
> >
> >>>>>>To: 
> >>>>>>Sent: Wednesday, January 04, 2006 12:34 PM
> >>>>>>Subject: [TechAssist] pt-51g36ce convergence
> >>>>>>
> >>>>>>
> >>>>>>
> >>>>>>
> >>>>>>
> >>>>>>
> >>>>>>
> >>>>>>
> >>>>>>            
> >>>>>>
> >>>>>>>Hello everyone
> >>>>>>>
> >>>>>>>Does anyone have the service manual for this
> >>>>>>>
> >>>>>>>
> >>>>>>>              
> >>>>>>>
> >>>set. Picture severely
> >>>
> >>>
> >>>      
> >>>
> >>>>>>>bowed top and bottom, convergence way off. I
> >>>>>>>
> >>>>>>>
> >>>>>>>              
> >>>>>>>
> >>>replaced both stk392-110
> >>>
> >>>
> >>>      
> >>>
> >>>>>>>and I cannot find any bad resistors. I am
> going
> >>>>>>>
> >>>>>>>
> >>>>>>>              
> >>>>>>>
> >>>to try to order the
> >>>
> >>>
> >>>      
> >>>
> >>>>>>>eprom again. Not in stock last week. Has
> anyone
> >>>>>>>
> >>>>>>>
> >>>>>>>              
> >>>>>>>
> >>>here replaced the
> >>>
> >>>
> >>>      
> >>>
> >>>>>>>eprom? If the eprom is the cause I should at
> >>>>>>>
> >>>>>>>
> >>>>>>>              
> >>>>>>>
> >>>least be able to reset
> >>>
> >>>
> >>>      
> >>>
> >>>>>>>the parameters for the convergence the
> setting 
> 
=== message truncated ===


Manuel
Orion TV Repair
(323)807-9876
Los Angeles 
CA 90001
-----------------------------------------------------------------------------
This Email List is accessible to the general public through search engines. 
Remove: http://www.tech-assist.org/remove.htm
Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation
Lost Password: http://www.tech-assist.org  and select "Login Problems?".
Email Archives: //www.freelists.org/archives/techassist/

Other related posts: