Pasted from force manual: Error Code #1 (an "off" flash of the LED) is an indication of: Vertical Failure X-Ray protection East-West Module failure If the first 2 are eliminated, the remaining cause of Error #1 may be the 7860 Power FET on the E-W module. The part may be replaced or the module replaced. For the 36" G7 use module 00A10781-A001 For the 32" G7 use module 00A10780-A001 Jim Myers jr.myers@xxxxxxxxxxx ----- Original Message ----- From: "joe weaver" <weavel@xxxxxxxx> To: "tech assist" <techassist@xxxxxxxxxxxxx> Sent: Wednesday, November 28, 2001 3:51 PM Subject: [TechAssist] magnavox 32d7 chassis dead set > > hello everyone, > this set came in dead..when power button is pressed the light on front panel > blinks 5 times then pauses then blinks again 5 times..i dont have a service > manual on this set..so any info would be helpful ..thank you...joe > > > william j.weaver > weavers electronics > 268 w.water st. > oak harbor,ohio 43449 > 1-419-898-4129 phone > 1-419-898-5054 fax > "God Bless America" > > ================================= > Help make your TechAssist database better! > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > ================================= > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > ================================= Help make your TechAssist database better! Submit your fixes here: http://circuitwork.com/techassist/tip/#tips ================================= To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe