Hi Roy check this out Eric CF36G40 Dead set, R883 smoked. B+ present, no fuses blown. Relay clicks, but no horizontal drive. Circuit path on 25 volt line has a factory break, (looks like a circle with a void in the middle). They use a ball of solder to bridge the void. One end lifts off the pad. Resolder Eric E M Electronics Deer Lake Nfld Canada tvman@xxxxxxxxxxxxxxx Royal19960@xxxxxxx wrote: > Hi all. > I have a Toshiba CF36G40 with a chassis TAC9609 > Symption dead set > I have +5 volts at the power switch and 13.2 volts at the relay coil > I get no base drive at the relay driver > I replaced the micro TMP87cm34bn-33 and checked caps (none bad) > Any iders? > Thanks in advance > Roy > > Bonded TV Service > 5158 W Forest Home Ave > Milwaukee, WI 53219 > 414-541-9111 > Web hosting from only 4.17 @ month at BondedHost.com > over 8,000 tubes at Bondedtv.com > > > ----------------------------------------------------------------------------- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/