Hi. I'm working on a thomson ICC5, and i noticed the 2.4V accu is starting to corrode. I was wondering: if i desolder this accu, all the channel presets will be lost, can i just put a new accu in parallel over the old one (on the solder side of the chassis, there's room enough), or will the old one short out eventually? BTW on this particual chassis the "loading circuit" consists of a simple RC network so it should be able to handle the extra loading current. Thanks for your opinions... Stefaan Van Slycken Van Slycken Elektro, Belgium. ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/