[TechAssist] Re: fix?: Symphonic (Funai) 13" TVCR SC3813. leaves a bit of tape out when Ejected]]]
- From: "al m" <ampm@xxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Tue, 6 Apr 2004 15:07:26 -0400
Did you check the gears for proper alignment on the bad one? If you had a
good one you should have seen something different.
Al Marquardt
ampm@xxxxxxx
Al Marquardt Electronic Repair
206 W Main
Girardville Pa. 17935
----- Original Message -----
From: "Phil Bader" <tjanphyl@xxxxxxxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Tuesday, April 06, 2004 2:55 PM
Subject: [TechAssist] fix?: Symphonic (Funai) 13" TVCR SC3813. leaves a bit
of tape out when Ejected]]]
>
>
> -------- Original Message --------
> Subject: fix: Symphonic (Funai) 13" TVCR SC3813. leaves a bit of tape
> out when Ejected]]
> Date: Tue, 06 Apr 2004 14:43:40 -0400
> From: Phil Bader <tjanphyl@xxxxxxxxxxxxxxx>
> To: bull >> Greg Paradise <bulldog@xxxxxxxxxx>
>
>
>
> (OK I cheated...but the end justifies the means)
> FIX: step-by-step procedure:
> Put down your Doctor Pepper.
> Find a good Funai 13" TVCR from the back.
> (save the flyback...need that later!)
> Pull the almost new deck.
> Clean mode switch.
> Clean/lube mech.
> Swap salvaged good as new mech (with very low use) for the ****** up one.
> Test. Works.
> Set ****** up deck aside.
> With magic marker pen,on the old deck, clearly mark "***** up" for
> future use.
> Job done...
> ;-)
> Phil
>
> -------- Original Message --------
>
>
>
>
>
>
>
>
>
>
>
>
>
> -------- Original Message --------
> Subject: Symphonic (Funai) 13" TVCR SC3813. leaves a bit of tape out
> when Ejected
> Date: Tue, 06 Apr 2004 13:41:37 -0400
> From: Phil Bader <tjanphyl@xxxxxxxxxxxxxxx>
>
>
>
>
>
> Symphonic
> SC3813( 13 inch Funai made). Type with the single belt at rear.
> Orig. complaint was ate tapes,etc. I cleaned the deck, relubed, cleaned
> mode switch, reinstalled. Replaced two tactile switches in front (had
> corrosive on them). And checked/retimed mech.
> Now, Will accept tape, auto load, play, allthe mechanical functions OK.
> Push "stop" and "eject" and will do so, but just before the tape ejects,
> it leaves a bit of tape out of the cassette to get snagged on something.
> Like it won't snap it in all the way. Just a bit.
> Suggestions?
> Phil Bader
>
> --
>
> Philip Bader
> Jan Phyl TV Inc. (estab. 1976)
> 3420 Recker Hwy. Winter Haven, Fl. 33880
> Fax (863) 299-8821
> email: tjanphyl@xxxxxxxxxxxxxxx
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> --
>
> Philip Bader
> Jan Phyl TV Inc. (estab. 1976)
> 3420 Recker Hwy. Winter Haven, Fl. 33880
> Fax (863) 299-8821
> email: tjanphyl@xxxxxxxxxxxxxxx
>
>
>
> --------------------------------------------------------------------------
---
> Lost Password:
> http://www.tech-assist.org and select "Login Problems?".
> Email Archives:
> //www.freelists.org/archives/techassist/
>
>
-----------------------------------------------------------------------------
Lost Password:
http://www.tech-assist.org and select "Login Problems?".
Email Archives:
//www.freelists.org/archives/techassist/
Other related posts:
