Replaced shorted Q906 (2sd1556, not sure if it's proper designation is "deflection" or "HOT"), Open R934 (.33 ohm) and fly (4835-1406-7128). I noticed a leaking lytic on the top edge of the same defl board: C827 (1000/25V). Replaced cap , fired up set with good picture, except I will replace the fluid in two CRTs to complete the job. Phil Bader Phil Bader wrote: > This had sound, no HV. > Deflection transistor Q906 (2SD1556) shorted, associated resistor R934 > open (.33 ohm) . > Suspected bad flyback 4835-1406-7128. (from past emails) > Ordered all three. > The fly anode is connected to the HV block. It looks like it's attached > with a plastic insert in the fly. > Don't want to force it. > How do I release the anode wire from fly properly? > Phil Bader > > -- > > Philip Bader > Jan Phyl TV Inc. (estab. 1976) > 3420 Recker Hwy. Winter Haven, Fl. 33880 > Fax (863) 299-8821 > email: tjanphyl@xxxxxxxxxxxxxxx > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ -- Philip Bader Jan Phyl TV Inc. (estab. 1976) 3420 Recker Hwy. Winter Haven, Fl. 33880 Fax (863) 299-8821 email: tjanphyl@xxxxxxxxxxxxxxx ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/