U4101pins 15 and 16 should both be about 10 volts. You should have about 69 ohms between them, and c4118 is 470uf. R4003 feeding this stuff is 33k ohms. See if you measure these. Wayne Vanaman Omega Electronics 6904 W Fairfield Dr Pensacola, Fl. 32506-3310 Wayne@xxxxxxxxxxxxxxxxxxxxx WWW.PensacolaTVRepair.Com 850-456-5995 voice 850-458-6369 fax pete wrote: > I have been stumpt on this one. 120 volts on horiz output transistor in > standby. cr4118 has been replaced I dont have 15 volts on diode I cannot > measure it fluctuates c4145 1000 micro 50 volts have been also replaced raw > bplus is 160v on the money I have replaced c102,c108.c104 u101, and > disconnected the audio. Any help will be greatly appreciated > Pete > > Perdomo Tv Inc Since 1972 > Miami.Fl > ----------------------------------------------------------------------------- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/