If you replaced the splitter in this first---then you probably bumped the centering rings on one or two of the adjacent crts. Been there done that. Make sure to adjust convergence back to center of range then adjust the centering rings TV Doctor Avalon, Wi ----- Original Message ----- From: "Andrew Soltes" <atv2@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Saturday, April 17, 2004 5:16 PM Subject: [TechAssist] blue conv setup ptk169 > hello everyone > i have this monster ptk169 chassis that will only let me adjust > the blue conv within a 1/4 of an inch of my red and green cross hatch > leaving all the imadges with a blue out line i checked all plugs going to the conv board and they are in the right position i check the filters (esr) found nothing also checked transistor and voltages nothing off, on the ptv aux board lost a this point and i have a cust getting mad. maybe some knows what i've missed . thanks for any help andy > Andy's TV & VCR Service > 662 McKean Ave > Donora,Pa. 15033 > 724-379-8559 voice/fax > atv2@xxxxxxxxxxxxx > > > -------------------------------------------------------------------------- ------ > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/