Tim Did you resolve your problem? I have one doing a similar thing. The source voltages check good, suspect a bad STK after it gets hot it starts the shift. If I unplug the blue convergence it stays ok on others. Afraid problem may be on the convergence board. Customer reluctant to spend much so I am doing little until I get an ok to proceed. Bill Dravenstott Elza's Home Store 924 Union St Ashland, OH 44805 ----- Original Message ----- From: "Tim Poole" <tdp13158@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, February 25, 2004 10:56 PM Subject: [TechAssist] Zenith projo looses convergence pulses > I am working on a Zenith projo that begins to pulse with loss of convergence correction after it has been on about 15 minutes. I have replaced the 9-1302-7 deflection and the 9-1318-2a convergence board with no results. Anyone seen this? Weird! > Tim Poole pooletim@xxxxxxxxxxx tdp13158@xxxxxxxxxxx > dba A-Mobile TV Shop & Precision TV Service > 17626 Shady Lane > Fredericktown, Ohio 43019 > 419-756-3443 > 740-694-8585 > fax 740-694-1032 > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/