Just repaired the 9-1194 sweep board and picture is good except for drive lines that are predominant on the left but go across the screen. Almost like tearing that c2212 causes on the 9-1130. I've gone over caps on the 9-1225 signal board and pip and only found a couple that were marginal. This thing is a beast to dog out in a service position, so need to get it while the board is out. Anyone have a clue or had a similar fail. Thanks for any. Terry H. The TV Shop 314C St. George St. Gonzales, Tx 78629 830-672-7403 ***************************************************************************** CHECK OUT THE NEW CHATROOM! Just login and click on chat! http://www.tech-assist.org/secure/tip/main.htm The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/