Have you set the master width and V-height?They are located on the 1674 at the front,if set improperly the conv pcb will be over-stressed. I think I have the factory info will send to you if you needed. Country TV Ron Miller 484 FM444 S. Inez,TX 77968-5002 V.(361)782-6419. F.(361)782-9149 e-mail: rlmbkm@xxxxxxxx ----- Original Message ----- From: "mark brock" <brock@xxxxxxx> To: "Tech Assist Group" <techassist@xxxxxxxxxxxxx> Sent: Wednesday, November 20, 2002 8:43 PM Subject: [TechAssist] Zenith Z60Z83R > > 1674-01 chassis, had hv problems, ordered board from Union ( on sale > $79.00) sent me a -03, put it in and have pin coushion problems, bows in > from all 4 sides. so is it on this board or what ? the convergence > board is also new. sure appreciate any help, > brock > Brock Electronics > R.R.4 box 237 > 5208 cr.3385 > Independence Ks. 67301 > 620-331-0235 > fax 331-7191 > > brock@xxxxxxx > mailto:brock@xxxxxxx > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/