These are from WINSTIPS: --------------------------------------------------------------- Text pasted from WinSTIPS 2.0 http://www.ServiceSoftware.com --------------------------------------------------------------- ZENITH SS8769H2 Dead Raymond rivet 9-840 mainmodule: Cx2107 2200/50, C3407 100/50 --------------------------------------------------------------- ZENITH SS8769H2 Dead (Sometimes Led Will Display &Relay Will Click) Mike Rilee C.C.S. Replace Q2 2n3904 Or Sk3854 , Cr5 1n4004, & Cr6 12v Zener Diode On Relay Board & Resolder Conections On Bottom --------------------------------------------------------------- ZENITH SS8769H2 No High Voltage, Channel Led Is On And Set Tunes, Audio Ok Too Marshfield Tv Check/Replace Q3209 On 9-186. Zenith Part # 121-1040, Ecg123ap --------------------------------------------------------------- ZENITH SS8769H2 Start-Up Inop, 150v Ok... D.A. Electronics R3213 100 Kohm Resistor In Multivibrator Circuit Was Open. No Start Pulse On Driver. --------------------------------------------------------------- ZENITH 9-822 Dead Orlan Stone, Cet Horiz Driver Xmer Burned. Q3404 Leaky (121-1264-1), Q3206 (121-1290), Tx3205 (95-4135-2). Also Check For Open Resistor In Series With Cr3434 Anode. 100 Ohm, Not On Schematics. --------------------------------------------------------------- ZENITH 9-822 Dead gilbert Module 9-822: C3407 100uf/25v --------------------------------------------------------------- ZENITH 9-822 Dead - Surge Damage Marshfield Tv Bad Icx3401, Uc3842an, Ecg7096. Shorted Chopper Transistor, Irf740, Ecg2397. Blown Fuse. --------------------------------------------------------------- ZENITH 9-822 Dead Or Int. Rick'S Tv C3407 --------------------------------------------------------------- ZENITH 9-822 Dead Or Int. Also On 9-823, 9-824 & 9-1074 Possible A Few Others C3407 100/25, This Is Normal For This To Be Bad In Most Cases Of No Hv ,However Found Another With A Shorted Vertical Ic Which Wont Let Hv Come Up,If Intermitt Its Cap Only//Emergency Tv Electronics --------------------------------------------------------------- ZENITH 9-822 Dead. Green Stereo Led Flashes On & Off Cx3402 100uf/25v --------------------------------------------------------------- ZENITH 9-822 Dead. No Startup. No P.S. Squeal Billdog Icx3401. I Had Replaced C3407 A Year Or 2 Before On This Set --------------------------------------------------------------- ZENITH 9-822 Dead. starts to come up (relay clicks 2x) works sometimes tvkirk Flushing MI Cr3434 ecg116 was 470 ohms resistance --------------------------------------------------------------- Bob Waterman, CET® #RI-28 Master Technician License #9109 Service Manager Gemini Computer, TV, & Security Alarms (508)695-7302 (508)695-7769 FAX geminitv@xxxxxxxxxxxxxxxx geminitv@xxxxxxx ----- Original Message ----- From: "Leonard G. Caillouet" <lcaillo@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, November 20, 2002 3:14 PM Subject: [TechAssist] Zenith SS8769H2, 9-840-1, 9-822-1 no power > > Any of you zenith experts have some tips on this one? I have no manual (NLA > from Zenith) and no experience with this set. The set will not power up. > Relay clicks twice. Power supply has output on secondary, 135v at HOT > collector. FBT tests good, nothing happens at HOT except slight drop in dc > at collector when it tries to turn on. No drive signal at all appears. > Micro is powered and it does respond to power button. > > power/deflection module is 9-840-1 > control/video module is 9-822-1 > > I am guessing that the VCJ is IC2301 (221-518). can anyone tell me anything > about it? Where is it supplied from, H drive at what pin, etc? It appears > to not be powered... > > None of the Zenith manuals that I have contain anything like these modules. > Any help would be appreciated. > > Leonard G. Caillouet > Service Manager > Electronics World > Gainesville, FL > 352-332-5608 > 352-332-5668 (fax) > > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/