Max, Remove output transistor... Plug set in, see if you have 130 volts on collector tab...If no 130V troubleshoot power supply.. With 130V you could have shorted fly... I would remove the sweep board and resolder all regulators diodes etc.... Make sure you resolder all of the pins on the cable plug sockets to other module..Not sure about this model but there was a Zenith model, if horiz drive lost, output transistor shorts at turn on.. Hope this helps.. Bob Bob's TV Worcester, ma -----Original Message----- From: Old TV Man <mebonnell@xxxxxxxxx> Sent: Sep 22, 2004 1:40 PM To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Zenith SJ7773BG - Chassis 9-1134 & 9-1092 I found the HOT shorted and replaced it with a 121-1148. When turned on it shorted out again. I have a schematic that is close. Any suggestions are welcome. Max Bonnell Bonnell TV Robinson, IL ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/