There is a small cap on the deflection/power suply baord that causes this problem. I cant remember the location number but is is a 100uf 25v cap on the left side of the board near the rear. Shaun ----- Original Message ----- From: "Jim Myers" <jr.myers@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, January 02, 2002 1:09 PM Subject: [TechAssist] Zenith SF2721H with 9-754 and 9-753 modules, intermittent startup > > Set will turn on and stay on and work normally if power switch is pressed > four or five times. It is probably going into shutdown the first few times > since the power switch must be pressed twice to try to turn it on again, > once to reset the xray circuit and again to start it up again. Would anyone > know the cause of this problem, or at least which module the problem is on. > Thanks for any help. > Jim Myers > jr.myers@xxxxxxxxxxx > > ------------------------------------------ > Help make your TechAssist database better! > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. > ------------------------------------------ Help make your TechAssist database better! Submit your fixes here: http://circuitwork.com/techassist/tip/#tips ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.