When I work on the convergence board I replace both chips. Also check the 1ohm resistors on that board, Also on this model make sure all conver yoke plugs are in the related sockets. Also you might have a bad block. Avery Avery Boyd 4666B S. Mingo Tulsa OK 74146 Phone 918-665-2400 ----- Original Message ----- From: "Larry E." <videotech@xxxxxxxxxxxx> To: "tech-assist" <techassist@xxxxxxxxxxxxx> Sent: Wednesday, May 05, 2004 3:27 PM Subject: [TechAssist] Zenith PVY4665RK 9-1674 Now Convergence Problems Hi Guys, I have this projection set in the shop that was dead so I replaced the 9-1674 module, set now starts but picture is poor, replaced R5102 on Green crt board, picture improved some, checked the resistor on red & blue they are on the money at 120K. One of the convergence IC`s is running hot (IC4009) so I replaced it, still runs hot, picture appears to be out of focus a little on the right upper side of the screen and my convergence is off a little on both red & blue, I don`t have the print of course, tried the 98xx enter for factory service but don`t see anything for convergence adjust, I need some help on this one, I`ve got way too much time and money in this one already and the customers getting impatient, tia, Larry E Larry Eastman American TV & Electronics Crystal River, Fl. ---------------------------------------------------------------------------- - Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/