If the convergence board is using stk392-110 replace them along with the 1ohm resistors. Avery Boyd 4666B S. Mingo Tulsa OK 74146 Phone 918-665-2400 ----- Original Message ----- From: "LeRoy Westlund" <llw@xxxxxxxxxx> To: "TechAssist" <techassist@xxxxxxxxxxxxx> Sent: Tuesday, April 20, 2004 10:46 PM Subject: [TechAssist] Zenith PVR4660VK Pix is bowed equally on top, bottom, and sides, and convergence is bad. Hi members, I repaired my focus problems by replacing the Focus block. I still have bad convergence, and the pix is bowed equally on top, bottom, and both sides. Does anybody have a fix listed for this problem ? I don't want to buy convergence amps, cause I'm pretty sure it won't fix the problem. I'll buy some if you guys think I need them. Can't afford to waste money buying parts that won't help. So far,..so good,...but,..I need a quck fix,...bad ! Any help is appreciated, LLW LeRoy Westlund Westlund TV & Electronics 97 North Main "Where there's a will,... Centerfield, UT 84622-0087 There's always a way." Ph./Fax 435-528-3822 mailto:LLW@xxxxxxxxxx ---------------------------------------------------------------------------- - Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/