Jose, First suspicion is the convergence module. You're going to have to post the main module/conv module numbers so we have an idea of the set you have. Jeff -- Intrepid Video TV/VCR Repair 263 S Front St, Steelton PA 17113 717-939-7708; (F) 717-564-4952 www.intrepid-video.com www.tech-repair.net ----- Original Message ----- From: "javiles6" <javiles6@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, May 03, 2004 1:51 PM Subject: [TechAssist] Zenith PV5263RK(Need help) Hello Techs I been working in this set for quite a while and now that i finally have it to turn on, after a minute or so it goes into a hourglass form. Before this problem the set had sound but no picture. Replace a shorted HOT but it blew it instantly. So i replace the flyback, put in an original HOT change about 10 caps in SMPS. Also a couple of diode, resolder both boards. At first turn on set was fine but the convergence was out of wack, while adjusting it the set started bowing in from the middle, if i turn it off and back on it works fine again but then the problem comes back. Any ideas what i have miss or anything else need to be replace. I have no schematic but i`m just working with a little bit of experience on other zenith model i have work on before. I was thinking a regulator problem but maybe one of you techs out there have confront this problem and may give me an idea. Your help like always is very appreciated. Thanks Jose Aviles Computer & TV Repairs 508 Bingaman st Reading, PA 19602 tel # 610-478-1342 ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/