Matt, are you sure it doesn`t have the R5xxx 120K 1/2w resistors on those crt boards? You have to pull one leg to check them and your symptom is usually caused by those resistors. (theres one on each crt board) May not be your problem but I would double check just to be sure Larry Eastman American TV & Electronics Crystal River, Fl. 34428 matt sherer wrote: > Zenith PTV > Model: PVY4662DT > Unit came in with bad convergence. I was able to adjust the convergence > through the menu but seemed to be a problem. I replaced the convergence > module but still no help. Red seems to be smearing off to the right and > blue slightly to the left. Looks more like a smearing problem as opposed to > a convergence problem. I checked the components on the blue and red CRT > boards and nothing was bad. I have no print for this model so any help > would be appreciated. TIA!! > > Gear Guy > Electronic repair > A/V systems design, maintenance and installation > AMX programming > Matt Sherer, CET > 1411 Honeysuckle Lane > Champaign, IL 61821 > (217)356-9479 > m.sheer@xxxxxxxxxxxxx > > > ------------------------------------------ > Submit A Repair Tip For Everyone Here: > http://www.tech-assist.org/secure/tip/main.html > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > > > -- Larry Eastman American TV & Electronics Crystal River, Fl. http://www.tvjunkyard.com ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html