I wouldn't be surprized if you found the vertical output ic defective. It may even have a hole in it under the bracket. Be sure and check/change the elyc.caps. HTH Walter --- Rich Bateman <rbateman@xxxxxxxxxxxxxxxxxx> wrote: > > This set will not power up. no high voltage. > The HOT has 125 Volts on the > collector and while the switch is held in horz > pulses can be seen on the > base of the HOT and the high voltage attempts to > come up. After checking > the voltage sources I found that the 9v source is > not putting out. I > replaced Q3402, Q3404, Q1405, and the LM7809. All > associated caps were > checked with ESR meter. Still no power up. Could > this be a shutdown > problem???. Anybody out there have experience > with this model Zenith. > Thanks for any help you can send my way. > > Rich > > Richard J. Bateman, CET, CA. > Electronics Program Area Coordinator > Amherst Campus > 716-691-0012 EXT - 232 > E-MAIL rjbateman@xxxxxxxxxxxxxxxxxx > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ===== Walter Wood Future Tech Home Center 2786 Hwy. 43 N. Lawrenceburg Tn. 38464 931-829-3337 Fax 931-829-4044 mailto:wwood_38478@xxxxxxxxx __________________________________________________ Do you Yahoo!? Yahoo! Web Hosting - Let the expert host your site http://webhosting.yahoo.com ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/