Yamaha Stereo Model RX-V595 This unit came in dead after lightning storm. I found the power supplies were OK but the Micro(IC800) wasn't doing much. Replaced the micro and I could turn on the power and the normal display came up but it shut off after two seconds. I fluxed all the micro leads and reflowed the solder, cleaned it up with flux off and checked with magnifying lens that all the pins are clean with no shorts or loose pins. I then held down the input mode & FM/AM buttons while pressing the standby button and my diagnostic display says " 1 DVD/LD DC = 0% " then it shuts right down again. The protection pins 23,24 & 25 are very close to what the schematic says they should be. None of the protection transistors in my amplifier circuits are triggered. I checked all 100 pins of the micro for proper voltages and waveforms. My power supply comes up to normal voltages. I am becoming suspicious of the new microprocessor as being defection. Any body have any other ideas that I might be over looking? TIA, Dale -- Dale A. Lubow CET Harris TV & Appliance 335 Lincoln Way Ames, IA 50010 515-232-1109 (Voice) 515-232-3356 (Fax) HarrisTV@xxxxxxxxx ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/