Make sure the remote is the right one and it's on the right setting. I had one once that the switch from TV to VCR was broken. It didn't feel broken but after replacing micro I took it apart and sure enough stuck on VCR. Al Marquardt ampm@xxxxxxx Al Marquardt Electronic Repair 206 W Main Girardville Pa. 17935 ----- Original Message ----- From: <wjstv@xxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, December 23, 2003 4:55 PM Subject: [TechAssist] Wards TV (aka Zenith) MWJ2565Y5 remote not working > This is a Wards tv Signature 2000 made by Zenith and uses a 9-1154 module. > Tv works fine but does not respond to remote. We tried another remote > receiver but it didn't help. Appears to have signal coming from remote > receiver and into microprocessor. Microprocessor is 221-710-02. > > Is there a Sams that covers this module? Are there other Zenith modules > that use this microprocessor or is there a sub for this microprocessor? > > Jeff Smith > Smith TV Service > 1930 Main St > Newberry, SC 29108 > 803/276-9910 > > **************************************************************************** * > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ***************************************************************************** Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/